The electric current is given by:

*I* = *V* / *R*

**Corresponding units:**

ampere (A) = volt (V) / ohm (Ω)

This formula is derived from Ohm's law. Where we have:

V: voltage

I: current

R: resistance

If the electric power and the total resistance are known, then the current can be determined by using the following formula:

*I* = √(*P */ *R*)

**Corresponding units:**

Ampere (A) = √(Watt (W) / Ohm (Ω))

Where Phường is the electric power.

__Electric Current__The rate of flow of charge through a cross section of some region of a metallic wire (or an electrolyte) is called the current through that region.

Bạn đang xem: i=q/t

If rate of flow of charge is not constant then the current at any instant is given by the differential limit: *I = dQ/dt.*

If a charge *Q flows through the circuit for time t, then *

**I = Q/t.**The S.I unit of current is called **ampere (A)** (coulomb/second).

1 ampere = 6.25 × 10^{8} electrons/ sec

In metallic conductors the current is due vĩ đại the motion electrons whereas in electrolytes and ionized gases, both electrons and positive ions move in opposite direction. The direction of current is taken as the direction in which positive charges move.

In conduction although the current is only due vĩ đại electrons, the current was earlier assumed vĩ đại be due vĩ đại positive charges flowing from the positive of the battery vĩ đại the negative. The direction of current therefore is taken as opposite vĩ đại the flow of electrons.

If current is constant: *Δq = I.Δt * function of time:

*Charge= Area under the graph = ½ × t _{0} × I_{0}*

**To Find Current in Electrical Circuit**

For Simple circuit or single wire, we have:

For complex circuit with more than vãn one wire we can determine current by the means of Kirchhoff’s two laws

**First Law: **This law is based on the principle of conservation of charge and states that in an electrical circuit (or network of wires) the algebraic sum of currents meeting at a point is zero.

*The arrow head marked in circuit represents the direction of conventional current i.e. the direction of flow of positive charge, whereas the direction of flow of electrons gives the direction of electronic current which is opposite vĩ đại that of conventional current.*

*I _{1} + I_{4} + I_{5} = I_{3} + I_{2} + I_{6}*

**Second Law: **The algebraic sum of the product of the current and resistance in any closed loop of a circuit is equal vĩ đại the algebraic sum of electromotive forces acting in that loop.

Mathematically .

Xem thêm: đường chéo hình lập phương

**Electromotive forces** – The *emf* (𝜖) of the source is defined as the work done per unit charge in taking a positive charge through the seat of emf from the low potential kết thúc vĩ đại the high potential kết thúc. Thus,

𝜖 = w/Q

When no current flows, the

*emf*of the source is exactly equal vĩ đại the potential difference between its ends. The unit of

*emf*is the same as that of potential i.e. volt.

The average flow of electrons in a conductor not connected vĩ đại battery is zero i.e. the number of không lấy phí electrons crossing any section of the conductor from left vĩ đại right is equal vĩ đại the number of electrons crossing the section of the conductor right vĩ đại left .Thus no current flows through the conductor until it is connected vĩ đại the battery.

**Drift velocity of không lấy phí electrons in a metallic conductor**

In the absence of an electric field, the không lấy phí electrons in a metal randomly in all directions and therefore their average velocity are zero. When an electric field is applied, they are accelerated opposite vĩ đại the direction of the field and therefore they have a net drift in that direction. However, due vĩ đại frequent collisions with the atoms, their average velocity is very small. This average velocity with which the electrons move in a conductor under a potential difference is called the **drift velocity.**

If **E** is the applied field ,**e** is the charge of an electron, **m** is the mass of an electron and** τ** is the time interval between successive collisions(relaxation time) ,then the acceleration of the electron is

Since the average velocity just after a collision is zero and just before the next collision, it is a τ, the drift velocity must be:

If I is the current through the conductor and *n** is *number of không lấy phí electrons per unit volume, then it can be shown that:

The

**mobility**

**µ**of a charge carrier is defined as the drift velocity per unit electric field:

*Current mật độ trùng lặp từ khóa (J)*

*(i) *

*(ii) **S.I Unit of J = Am ^{-2}.*

(iii) Current mật độ trùng lặp từ khóa is a vector quantity its direction is that of the flow of positive charge at the given point inside the conductor.

(iv) Dimensions of current mật độ trùng lặp từ khóa =

*[M*

^{0}L^{-2}T^{o}A^{1}]Current carriers: The charged particles whose flow in a definite direction constitutes the electric current are current carriers. The current carriers can have positive or negative charge. The Current is carried by electrons in conductors, ions in electrolytes and electrons and holes in semi conductors.

**Example 1: **A particle having charge q coulomb describes a circular orbit. If radius of the orbit is R and frequency of the orbital motion of particles is f, then find the current in the orbit.

**Solution: **Through any section of the orbit, the charge passes f times in one second. Therefore, through that section, total charge passing in one second is fq. By definition i = fq.

**Example 2: **The current in a wire varies with time according vĩ đại the equation I = 4 + 2t, where I is in ampere and t is in sec. Calculate the quantity of charge which has passed through a cross-section of the wire during the time t = 2 sec vĩ đại t = 6 sec. ** **

**Solution: **Let dq be the change which has passed in a small interval of time dt.

Then dq = I dt = (4+2t)dt

Hence, total charge passed during the interval t = 2 sec and t = 6 is

q = ∫

^{6}

_{2}(4 + 2t) dt = 48 coulomb

**Example 3:** Given a current carrying wire of non-uniform cross-section. Which of the following is constant throughout the wire?

**(a) **Current only

**(b) **Current and drift Speed

**(c) **Drift tốc độ only

**(d) **Current, drift speed

Xem thêm: giáo dục địa phương lớp 7

Solution**:(a)**

**Example4:** When potential difference across a given copper wire is increase, drift velocity of

charge carriers:

**(a) **Decreases

**(b) **Increases

**(c) **Remain same

**(d) **Get reduced vĩ đại zero

Solution** :(b)**

## Bình luận